Tool Selector Chart
Accessories
New Marking Head
Cutting Fluid & Dispensing Systems
Operation Instructions, Programming, Installation & Parts Lists
General Tapping Information
RDT & RCT Delivered Read-To-Run
Tapping Safety
Check List for Good Tapping
Trouble Shooting
Request Quotation
Order Accessories & Cutting Fluid
Request or Download Literature
Your Local U.S. Tapmatic Representative
Tapmatic Worldwide Distribution
Warranty Registration
Repair Service
Contact Us
Send Us Your Tapmatic Application Results
Company Profile
  Tapping Handbook  
Back to Tapping Handbook Contents
Drill Selection: Inches / Metric
For Inch/Metric Taps & Decimal Equivalents

Note: Most drill size charts are based on using standard job drills which can drill over size by approximately .003. These charts are based on .003 over size condition to achieve the proper percentages of thread. With today's high precision drills, they are now capable of drilling to near net size. When using a high precision drill or a "G" drill you should refer to the drill size formula's in the "Tapping Formulas" section.

Drill Selection: Inches / Metric

Drill Selection: Inches / Metric

   
  See New TapWriter Dot Marking Tool in Action  
Send For Our New General Catalog or FREE DVD Video Demo

Tapmatic Corporation, 802 Clearwater Loop, Post Falls, ID 83854
208.773.8048 / 800.854.6019, Fax: 208.773.3021, info@tapmatic.com
Copyright © 2006 Tapmatic Corporation